© 2026 Nanjing Finechem Holdings Co., Ltd,
All Right Reserved
Product Name: EX-CELL ANTIFOAM GI
Recommended Use: Antifoaming agent for industrial applications
Supplier: EX-CELL Chemical Solutions, 245 Industrial Avenue, Houston, TX 77001, USA
Contact: Phone: +1-800-555-2450, Email: support@excellchem.com
Emergency: CHEMTREC: +1-800-424-9300
Product Code: ECAFGI-900
Date of Issue: January 5, 2024
GHS Classification: Eye irritation, Category 2B; Skin irritation, Category 3; Not classified as hazardous for aspiration or inhalation at room temperature
Signal Word: Warning
Hazard Statements: Causes mild eye irritation, may cause slight skin irritation, prolonged or repeated skin contact can lead to dryness
Pictograms: Exclamation Mark
Precautionary Statements: Avoid contact with eyes and skin. Wash thoroughly after handling. Do not inject, ingest, or inhale mist. Use in areas with good air movement.
Component 1: Polydimethylsiloxane, CAS No. 63148-62-9, Concentration: 67-73%
Component 2: Polyether Modified Polysiloxane, CAS No. 68937-54-2, Concentration: 18-23%
Component 3: Silica, Amorphous, CAS No. 7631-86-9, Concentration: 2-8%
Component 4: Water, CAS No. 7732-18-5, Concentration: 3-7%
Eye Contact: Rinse carefully with plenty of water for fifteen minutes, hold eyelids open; remove contact lenses if safe; seek medical advice if irritation continues.
Skin Contact: Remove contaminated clothing. Wash exposed skin with soap and water. If irritation persists, get medical attention.
Inhalation: Move to fresh air. If symptoms like dizziness or coughing occur, seek medical support.
Ingestion: Rinse mouth with water; do not induce vomiting unless directed by medical personnel. Contact a physician immediately for further advice.
Suitable Extinguishing Media: Water mist, foam, dry chemical powder, carbon dioxide
Specific Hazards: Decomposition releases carbon oxides, silicon oxides, and formaldehyde under intense heat
Special Protective Equipment: Firefighters should wear self-contained breathing apparatus and full protective gear
Hazardous Combustion Products: Carbon dioxide, carbon monoxide, silicon oxides
Explosion Hazards: Not explosive under normal conditions; avoid spraying on open flames or hot surfaces
Personal Precautions: Prevent skin and eye contact using gloves, eye protection, and protective clothing. Avoid breathing vapor, mist, or spray.
Environmental Precautions: Prevent leakage into drains, soil, or waterways; contain spill with inert absorbents (sand, earth, vermiculite)
Cleanup Methods: Collect with inert absorbent, shovel into suitable waste container for disposal; ventilate area, wash residue with soapy water
Safe Handling: Use only with proper ventilation, avoid eye and skin exposure. Keep containers tightly closed and upright.
Storage: Store in cool, dry, ventilated location away from incompatible materials. Protect from freezing and sunlight. Retain original containers and label integrity.
Exposure Limits: No occupational exposure limits assigned for main components; total particulates (OSHA PEL): 15 mg/m³
Engineering Controls: Install local exhaust or general ventilation to keep vapor or mist below recommended levels
Eye Protection: Chemical splash goggles
Skin Protection: Industrial gloves made of nitrile, latex, or neoprene
Body Protection: Long-sleeve coveralls or lab coat
Respiratory Protection: Not required under ordinary use; for major spills or prolonged use, select NIOSH-approved respirator if needed
Hygiene Measures: Wash hands, arms, and face after handling and before eating or drinking
Appearance: Milky white liquid
Odor: Slight, odorless to faint silicone scent
pH: 6.5–8.5 (undiluted)
Melting Point/Freezing Point: Below 0°C (32°F)
Boiling Point: Approx. 100°C (212°F, due to water content)
Flash Point: >100°C (non-flammable water-based product)
Evaporation Rate: Slower than water
Vapor Pressure: Not significant at room temperature
Relative Density: 0.98–1.02 g/cm³
Solubility: Dispersible in water
Viscosity: 250–400 cP (at 25°C)
Partition Coefficient (n-octanol/water): Not established
Decomposition Temperature: Above 180°C (may produce hazardous byproducts)
Chemical Stability: Stable under normal temperature and recommended storage
Conditions to Avoid: Excessive heat, freezing, direct sunlight
Incompatible Materials: Strong acids, alkalis, oxidizing agents
Hazardous Decomposition Products: Silicon oxides, carbon oxides, formaldehyde if heated above 150°C
Acute Toxicity: No data on acute oral, dermal, or inhalation toxicity for the mixture; major components show low toxicity based on available information
Skin Contact: Prolonged exposure may lead to dryness, mild irritation
Eye Contact: May cause mild irritation, redness
Ingestion: May cause gastrointestinal discomfort
Chronic Exposure: No evidence of chronic toxicity in repeated dose studies; no human carcinogenicity data
Sensitization: Low risk of skin sensitization
Aquatic Toxicity: Silicone polymers are considered not acutely toxic to aquatic life; persistence possible
Mobility: Low, due to high molecular weight of main ingredients
Persistence and Degradability: Material not readily biodegradable, long environmental half-life expected
Bioaccumulation Potential: Low for major silicone ingredients
Other Effects: No notable impact on sewage treatment operations at standard use concentrations
Disposal Method: Dispose in accordance with local, regional, national, and international regulations; incineration or landfill authorized for non-hazardous industrial waste
Container Disposal: Triple-rinse empty container, recycle or dispose following local standards
Precautions: Do not discharge to surface waters; avoid uncontrolled release into soil, groundwater
UN Number: Not regulated as hazardous for transport
Proper Shipping Name: Non-hazardous for ground, sea, and air shipment
Packaging Group: None assigned
Hazard Class: Not classified
Labels Required: None
Special Precautions: Prevent package damage in handling, avoid exposure to freezing temperatures during transit
US TSCA: All components appear on TSCA inventory
SARA Title III Section 313: No reportable quantities
California Proposition 65: No known ingredients listed
REACH (EU): Not classified as hazardous, all substances registered or exempt
Other Regulatory Status: No components classified under WHMIS, OSHA, DOT, IMDG, or IATA as hazardous
